Ball Washing Machine consist of two washing cone assemblies. First is for primary washing and second is for final washing. Each cone consists of inner cone and outer cone. Outer cone is mounted on rigid frame. It is fixed and inner cone is held in rigid shaft, which is located in outer cone below and coupled with housing assembly. Housing assembly is specially designed to achieve rotary motion as well as up and down movement of inner cone.
Due to this, gap between inner cone and outer cone can be changed as per ball sizes. Sponge lining is made for every cone (Outer surface of inner cone and inner surface of outer cone) Rotary motion is transmitted to both cone assemblies by drive motor.BALL WASHING MACHINESSpecially designed drain type chute is mounted in between primary cone to secondary cone to travel the drained balls easily. Nozzle assemblies are mounted on outlet chutes of both cone assemblies and taps are also provided in both cone assemblies. Two separate tanks are located below these cones. Two separate pumps and filters are mounted on these tanks.
|01.||Overall Dimensions||1330 L ´ 1100 W ´ 1850 H|
|03.||Filtration system||Cartridge type, 5 / 10 micron|
|04.||Total Electrical power required||3 H.P./ 2.2Kw, 440VAC, 5 Amp,|
|05.||Washing spray Pressure||1.5 bar pressure|
|06.||Component size range||2.5MM. – 6MM. |
4MM. – 15MM.
6MM. – 22MM.
12MM. – 30MM.
|07.||Washing efficiency||0.003 mg / ball|